Loop wiring and concrete work in one visit
For this Los Angeles project, OB Garage Door & Gate replaced the loop-system wiring. The scope included cutting the concrete for the new wiring and restoring the worked areas afterward. The photograph and short site video show the marked loop layout on the concrete.
The work included
Oshri's service notes describe the wiring, surface work and sensor work carried out at the property.
- Replacement wiring for the loop system.
- Concrete cutting for the wiring route and restoration of the worked areas.
- Sensor rewiring and testing.
What the site documentation shows
The images capture two stages of the work: the loop layout marked on the concrete and the sensor wiring at its mounting point. They are progress photographs from the actual visit. The completed scope also included the concrete restoration and testing described above.
Planning a loop or sensor service visit
When requesting service, tell us your city or ZIP code and describe the issue you are seeing. A wide photo of the entrance, a photo of the operator label and pictures of the existing loop area or sensor help us prepare for an on-site assessment.
Please take photos from a safe position without entering the path of a moving gate. We can discuss the wiring and surface work your property may need after reviewing the existing setup.
Photos from the service visit
Site video
The camera follows the marked rectangular loop path across the concrete and toward the wall beside the drain. This clip documents the layout stage of the work.